Clary Corporation DT1000RET Specifications

Owner’s Operating Manual CONTINUOUS POWER SYSTEM DIGITAL TECHNOLOGY CT SERIES Models Covered: CT1000R CT1250R CT1500R CT2000R CT2400R Information c

THE CONTINUOUS POWER COMPANY Page 10 INSTALLATION f the unit is to be stored, it is recommended to refresh the internal battery at least once every

THE CONTINUOUS POWER COMPANY Page 11 OPERATION nce the system has been properly installed, it is ready to operate. The following procedures will ex

THE CONTINUOUS POWER COMPANY Page 12 SIGNALS AND INTERFACING t the rear of the unit are two DB-9 subminiature, female connectors. These are provi

THE CONTINUOUS POWER COMPANY Page 13

THE CONTINUOUS POWER COMPANY Page 14 SPECIFICATIONS ELECTRICAL Input Voltage (Selectable) 120VAC or 220VAC +10%, -20% (without Battery discharge

THE CONTINUOUS POWER COMPANY Page 15 MODEL SELECTION GUIDE MODEL NUMBER DESCRIPTION CT1000 CT1250 CT1500 CT2000 CT2400 Nominal VA (Max Watts)

THE CONTINUOUS POWER COMPANY Page 16 CARE AND MAINTENANCE his device is designed to be maintenance-free. It can be cleaned with a damp cloth or non

THE CONTINUOUS POWER COMPANY Page 17 SERVICE AND REPAIRour CT Series CPS is backed by one of the finest customer service teams available. Write or

THE CONTINUOUS POWER COMPANY Page 18 CLARY CORPORATION LIMITED WARRANTY STANDARD DT/CT/GT 800 - 2000VA and E3000 MODELS DEPOT REPAIR 1. TIME

THE CONTINUOUS POWER COMPANY TABLE OF CONTENTS TITLE PAGE NO. TABLE OF CONTENTS 2 INTRODUCTION 3 TECHNICAL DESCRIPTION 4 PACKAGING 6 PHYSICAL

THE CONTINUOUS POWER COMPANY Page 3 INTRODUCTION ongratulations! You have selected the highest quality protection for your continuous power needs.

THE CONTINUOUS POWER COMPANY Page 4 TECHNICAL DESCRIPTIONhe Digital Technology (DT) Series Continuous Power System (CPS) is a revolutionary new conc

THE CONTINUOUS POWER COMPANY FIGURE 1: CT SERIES BLOCK DIAGRAM BYPASS LINEEMERGENCYCUTOFFSWITCHVOLTAGE WINDOW DETECTOR COMMON MODE CHOKE RECTIFIER

THE CONTINUOUS POWER COMPANY Page 6 PACKAGING our CPS has been carefully packaged to withstand most abuse sustained during shipment. The packing ma

THE CONTINUOUS POWER COMPANY Page 7 PHYSICAL DESCRIPTION his section will point out and illustrate the various indicators, functions and controls of

THE CONTINUOUS POWER COMPANY Page 8 RACKMOUNT REAR PANEL VIEW 16 INPUT - AC Line power inlet 21 SIGNAL - Open-collector signal contacts 17 DC INPUT

THE CONTINUOUS POWER COMPANY Page 9 SYSTEM POWER SWITCH - The main control switch that engages utility power to the entire unit. By activating thi